I setup a CPU load sensor for a server using 48 cores CPU. For SNMP, it can show all 48 cores in form of "Channel". For WMI, it can only show 32 cores.
How can I make WMI CPU sensors show all 48 cores normally? Thanks.
CPU load sensor with WMI
Modified on 2025-06-10 22:24:00 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
You'll have to use the SNMP sensor for this one, we're limited by our 32 Bit Probe service here :)
May, 2016 - Permalink