Hello all, I have a building I want to periodically broadcast probe request from each AP and then read all the probe response. The manufacturing of the access points are Cisco and LinkSys.
How can programmatically access probe request and probe response on the access point?
Modified on 2025-06-10 22:24:58 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Please check if the vendor of your device offers any MIB files that can be used for this purpose.
If so, you can import a MIB with our MIB-Importer.
Then you can monitor the target with the SNMP Library Sensor.
Best regards
May, 2016 - Permalink