Hi,

In my PRTG, I go to generate a report "Highest adn lowest 1 minute averages" in on the sensor SNMP Traffic IN and OUT on a single device, the report is Wrong, only it shows a record and not the top 100 or Top xx, for example:

Report Prueba (26/04/2016 12:00:00 a.m. - 27/04/2016 12:00:00 a.m. 24 / 7)

Highest Averages (1 Minute Interval) Sensor Average Minimum Maximum Probe Group Device 1. fe0 493 kbit/s 0 kbit/s 889 kbit/s Monitoreo Local » Guadulupe Prueba

Lowest Averages (1 Minute Interval) Sensor Average Minimum Maximum Probe Group Device 1. fe0 493 kbit/s 0 kbit/s 889 kbit/s Monitoreo Local » Guadulupe Prueba

PRTG Network Monitor 15.3.18.3615 © 2015 Paessler AG Timezone: UTC-05:00 26/04/2016 11:38:47 a.m.

Article Comments

Dear Gustavo

Did you add more than one sensor to this report?


Apr, 2016 - Permalink

Hi Arne,

no, just add a sensor , I want is to get a top100 Highs and Lows 1 sensor SNMP Traffic.


Apr, 2016 - Permalink

Dear Gustavo

PRTG reports cannot show multiple minimums and maximums. The top 100 template shows the top 100 sensors out of all sensors included in the report.


Apr, 2016 - Permalink