Attempting to add SNMP sensor in PRTG on windows 2012 machine,but sensor not get response from the d
Modified on 2025-06-10 22:25:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi ,
I was Installed PRTG tool on my windows 2012 machine ,and added my ASA firewall to PRTG.When Adding snmp traffic sensor it says "sensor does not get response from device.snmp credentials are wrong or device does not support the
required uptime OID(1.3.6.12.1.1.3.0)." But there is no errors in snmp credentials,SNMP service is also running on the windows 2012 machine. What is the exact problem regarding this??
Article Comments
Hi there,
You will need to setup SNMP on the ASA device so that the information can be queried by PRTG. It will require a read only community, you can follow the Documentation of Cisco for the configuration.
Best regards, Felix
Apr, 2016 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
You will need to setup SNMP on the ASA device so that the information can be queried by PRTG. It will require a read only community, you can follow the Documentation of Cisco for the configuration.
Best regards, Felix
Apr, 2016 - Permalink