Cannot add sensors for Cisco Meraki MX series to PRTG
Modified on 2025-06-10 22:34:11 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hello,
I cannot add SNMP sensors for Cisco Meraki MX series to PRTG. The only information that I found at PRTG forum was related to Cisco Meraki Access Points but nothing about the MX series.
I have tried to import the MIB file to the PRTG console but I get an error saying missing interface.
Could someone help me on that? How can I add the sensor to monitor the bandwidth in an interface?
Thank you,
Article Comments
Hi there,
Here we have recently put together some information regarding Meraki devices.
Kind regards.
Feb, 2016 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
Here we have recently put together some information regarding Meraki devices.
Kind regards.
Feb, 2016 - Permalink