Hello,

I am adding the Dell PE System Health monitors to my dell servers, however one of them is showing an error in a channel that exists(shows) only on the system in question, other systems do not have/show this channel.

It is the "Ampere Status" channel, and it is in error state with last value of "Unknown".

Is there a way to remove this channel? Or turn it off? I cannot seem to figure out how to turn it off.

Thank you,

Article Comments

Hi,
I would recommend editing the used lookup file here. You can simply tell the sensor that the unknown status is ok this way without disabling any channels.
Best regards


Jan, 2016 - Permalink

Thank you! That solved it.

It will now forever remain in warning state.


Jan, 2016 - Permalink