I want to add sensor which the sensor calculate the percentage of the bandwith and if the bandwith upper than % 80 ,it will give alert to me.
Hello , Can I ask question? Is there any way that PRTG will automatically sence exact amount of lin
Modified on 2025-06-10 22:37:53 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi, you can use the SNMP Traffic Sensor here and then configure the same to show percentages instead of absolute values. Afterwards simply set up warning/error limits. Both can be done in the Sensor Channel Settings.
Best regards
Jan, 2016 - Permalink