Good morning,

I have several sensors with one type of configuration that it´s not working properly, the trigger for any value change.

I´ve enabled if the value change PRTG send a trigger notification to detect it, but in all of the cases I don´t see any change notification.

Thank you.

Article Comments

Hi,
Do you have added a Change Trigger on tab Notifications of the affected sensors?
Best regards


Dec, 2015 - Permalink

Yes, of course, it´s configured in both sites.


Dec, 2015 - Permalink

Hi,
Thanks for the info. Could you check tab Log of the sensor if the notification is triggered at all?
Best regards


Dec, 2015 - Permalink

I´ve configured another sensor with this type of triggers and it works, but the sensor that we need to check only changes the value once a month. When we saw the value change, it hasn´t working. The sensor that we use it is the snmp personalized sensor.


Dec, 2015 - Permalink

Hi,
Could you forward some screenshots to support@paessler.com. Please refer to this thread. Thank you!


Dec, 2015 - Permalink