Hello Experts,
I want to know that is it possible to assign custom sensor ID to sensor manually instead that PRTG assigns the sensor a random sensor ID.
Thanks
Assign custom sensor ID when adding sensor
Modified on 2025-06-10 22:42:06 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
no this is not possible. PRTG automatically assigns a sensor ID.
Best regards
Dec, 2015 - Permalink