IN PRTG we are seeing prob health check status is disconnected and unable to see any alarms in PRTG . how to trouble shoot this issue? it was working before. Now we can receive mails about device down or up but no alarms in PRTG tool.
Sensor Probe Health show as disconnected
Modified on 2025-06-10 22:43:18 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Kaladhar
Please specify if the sensor of the local probe is shown as disconnected, or if a remote probe is affected.
Dec, 2015 - Permalink